RESUMO
RATIONALE: Water-stable isotopes in rainfall are powerful tracers of atmospheric processes at different spatial and temporal scales. However, commercially available rain samplers for isotopic analysis are prohibitively expensive, especially for high spatial resolution networks and studies conducted in developing countries. A low-cost, simple, and robust sampler was designed for event and monthly rainfall samplings. METHODS: Rainfall collectors were built based on existing designs provided in the literature and using easily accessible materials. Event samplers were filled with different volumes of reference water and left for 72 h in laboratory conditions to determine the minimum amount of rainfall to be collected to minimize isotopic fractionation, from both postsampling evaporation and equilibration. Samples were analyzed using dual-inlet isotope ratio mass spectrometry and cavity ring-down spectroscopy. RESULTS: For samples larger than 4% of the bottle's capacity, the evaporative enrichment due to Rayleigh distillation is negligible compared to the overall analytical uncertainty. Using a tube connecting the funnel to the water sample has proved to reduce postsampling evaporation by at least five times. To limit water self-diffusion, we recommend collecting the largest rainfall amount possible. Under these conditions, these collectors are suitable for rainfall sampling for isotopic analysis. CONCLUSIONS: This low-cost methodology will enable isotopic sampling of precipitation at high spatial resolutions and democratize the use of isotopes for hydrological studies in developing countries. All instructions for building and using these samplers are made openly accessible to the scientific community so they can be repeated and adapted to the needs of each project.
RESUMO
The thermal mineral water of Peñón de los Baños spa (Mexico City) has been used for over 500 years starting in pre-Hispanic times and is famous for the treatment of various pathologies. It has a temperature of 45 °C, which is rich in HCO3-, and its main trace elements are B, Li and Fe, which confers healing effects. Concerns about the sustainability of this important spa have motivated this study to understand the thermal system, possible hydraulic and hydrochemical changes over time and its implications. Stable water isotope data indicate that the thermal water sources originate from local precipitation at Sierra de las Cruces with a recharge elevation of approximately 2770 m above sea level. The recharged water percolates through volcanic and carbonate rock formations and ascends via fault structure conduits, where it eventually is extracted 25 km downstream in Peñon de los Baños. During the gravity-driven deep circulation of up to 4.9 km, the groundwater is heated up to 136-160 °C. A comparison of past and current water levels and water chemical analyses indicates a water table drop and few variations in the chemical composition, confirming the presence of anthropic impact on water quality. Due to the heavy groundwater extractions in Mexico City, the spring water flow has ceased, and water must be pumped now from a 203-m deep well. In addition, the concentration of bicarbonate, sodium and chloride has been reduced by half since the onset of groundwater development. The therapeutic effects of this thermal mineral water are at risk due to the alteration of the chemical signature. However, new and different therapeutical uses may prevent a future deterioration or closure of this historically important thermal spa. It is crucial to establish a monitoring program of the thermal mineral water and reducing or minimizing nearby urban extractions which tap the regional flow component to preserve the properties of the thermal water.
